Page 1 of 1

Suggestion - Test command for overheating

Posted: Tue Sep 12, 2017 1:12 pm
by joefiesta
Hello,

If I enter a command to be executed when a certain temperature is reached, I can't TEST that command. It could be a very convoluted syntax, and I might not be sure it's correct.

I would like to suggest you add the ability to TEST a command that is supposed to be executed when a overheating occurs.

thanks


Joe Petree

Re: Suggestion - Test command for overheating

Posted: Fri Sep 15, 2017 12:43 am
by The Coolest
Thanks for the suggestion, I'll add it to the to do list.

Re: Suggestion - Test command for overheating

Posted: Sun Jan 14, 2018 9:18 pm
by steveshank
I set my overheat protection to below the current temperature to see whether it works. Then return it.

I kind of test by setting the alert temperature to a degree below the current temperature and watching. It always alerts me. Then reset the temperature to the default. Use manual, so I know exactly when it is supposed to alert.