Page 1 of 1

My tempetures

Posted: Mon May 02, 2011 3:38 am
by cragger
Just wandering if you think my temps are ok i have not use the off set as i don't no how 2nd pic is at idle 1st pic is at full load 100%

Could someone please help me out with this thank you.













Image

Re: My tempetures

Posted: Tue May 03, 2011 7:54 am
by The Coolest
You temps look great.

Re: My tempetures

Posted: Tue May 03, 2011 10:58 am
by cragger
Thank you for a quick reply. Now i have figure out how to use the offsets.

Do i set the offset to the highest or lowest temperature or just leave everything as it is.

thank you again cheers.

Re: My tempetures

Posted: Tue May 03, 2011 11:01 am
by The Coolest
You don't have to use the offsets at all, unless you find it necessary.

Re: My tempetures

Posted: Tue May 03, 2011 11:23 am
by cragger
Thanks Coolist for everything i was just abit worried about my #0 core reading higher above most but they seem to all level out at higher load, this is my first overclock from 2.66 to 3.2 with nothing left on auto, alot of google research, with alot of prime 95 testing, 24hrs on small FFTS and 24hrs on blend test no errors and ran memtest for 12hrs no errors. Is it worth running large FFT for 24hrs?


Cheers cragger

Re: My tempetures

Posted: Tue May 03, 2011 2:12 pm
by The Coolest
Usually it's best to let it run for 24 hours, at least.
There are other tools like Linx, which doesn't take as long as Prime95 to detect instability, but I suggest you read up on it before use.